F-9 Panther 2/5 variants LW-PLA

64mm edf version of the F-9 Panther using LW-PLA. Fuselage 2 is interchangeable allowing for recessed/non-recessed air-intakes which are common differences between the two variants. Set up is for a 3s parkflyer using a 64 or similar sized edf and 3 9g servos for quick and simple setup. Approximately 30″ in wingspan and length. Slots in wing and tail for reinforcement with dowel or carbon fiber. Elevator is a split design using a single servo/ a C-adapter for the servo arm is suggested as you will have two control rods controlling the split elevator. 2X 3mm bolts and nuts are used to close edf housing. Best print practices are 2 solid bottom layers and 3-4 solid top layers. You may need to create 3 slicing profiles to prevent the extra layers from affecting internal structures. 0.25 layer height on most parts except Nose and L/R wing tanks. 0.2 layer height to allow rounded surfaces to close properly. Battery tray is printed in standard PLA.