Cooling base for DJI Avata

DJI Avata cooling base. With this accessory I was able to cool internally from 75ºC to around 35ºC.
This base is important when you need to update the firmware and the internet connection speed is not that good and also on summer days.
I used a model 4020 12V cooler (measurements 40mm x 40mm x 20mm) and a 2A bivolt power supply, and M3x25 screws (4)
M3 locking nut (4)
STL Parts:
Base (1x)
Blower (1x)
Rod (4x)
Blower Cap (2x) Use some cyanoacrylate glue to close the blower tip, this small piece serves as a base and air deflector.For identification, the cap is black in the photo and the blower is orange.