Hard Enclosure for Purethermal Mini

This enclosure was developed as a compact, modular, and cost effective means to provide reasonable protection for the Purethermal Mini USB thermal camera board sold by GroupGets. Each completed unit with heatsink cover takes approximately 1 hour to print using PETG and uses 1.47m of 1.75mm filament when printed at 100% scale. Also included is an example window module that allows for the use of LDPE film (aka grocery bags) as a cost effective way to protect the optics of the Lepton sensor module.
To assemble and install the example window the beveled front ring fits over the smaller inner ring, and the window material should be stretched between the two pieces and pressed in with the inner ring. The excess material should be cut and the protruding section of the inner ring slides into the front window opening of the main enclosure.
Note that the STL models are sized to exact dimensions, it is recommended that you rescale the parts before slicing to accomodate for your printer’s precision tolerances.
This enclosure was designed for the Purethermal Mini MicroUSB model and has been tested and verified to work with this model. Since both models have the same PCB layout and dimensions this case should also work with the JST-SR Pro model with minimal or no modification, however this is not verified.